Pugmill adaptor

pug adaptors x3.jpg
pug adaptors x3.jpg

Pugmill adaptor

from 279.00

This is our pug mill adapter it can be easily adjusted to fit your pug mill. You will have to drill your own holes into the adapter due to inconsistencies with different versions of pug mills.

 

SIZE:
Quantity:
Add To Cart
pug adaptors x3.jpg

Our  pugmill adapter are designed to make it easy to refill our poly-carbonate tubes. These adapters fit most common pugmills and we can provide custom adapters.

We have 3 primary types of adapters. The most common is the 2000ml adapter with 7 inch round plate undrilled. This plate is ideal for a variety of pugmills. After you receive the pugmill adapter you will have to drill holes to match your flange holes. Some pugmills like the Venco have a substantial flange but typically have no holes so in this case it's necessary to drill and tap for fasteners. Typically four or five M6 or M5 Fasteners are sufficient.

The second pugmill adapter is for our 3600/4000 tubes. Again, just with a circular plate for adapting on to various pugmills.

The third pugmill adapter is a little more complicated and requires substantially more machining. These adapters are for the larger pugmills like the Peter pugger VPM60 and similar pugmills.

It's become a little difficult with all the different hole patterns so the best results are achieved if you provide us with a simple pattern of the holes or even what we call a rubbing of the holes. This can be easily accomplished by placing clean paper over the flange and using the edge of a pencil and gently finding the inside and outside parameters along with the holes. This way we can match up your pugmill hole pattern.

Untitled-1.jpg